C13, C15, and C18 Tier 4 Final Engines Caterpillar

Magnetic Pickup

Usage:

826K 232

Show/hide table




图 1	g03348291

Show/hide table

表 1
388-8890 速度传感器总成的技术规格
项目	数量	零件	技术规格说明
1	1	5N-6753 速度传感器总成	发动机停机时，将转速传感器总成安装到 5/8 螺纹孔内。速度传感器总成接触到飞轮齿圈后，后退 180 ± 10 度。
			将锁紧螺母拧紧至扭矩为 49 ± 7 N·m (36 ± 5 lb ft)。
			速度传感器总成和飞轮齿圈之间的间隙为 0.55 至 0.83 mm (0.022 至 0.032 in)。

Caterpillar Information System:

3516C Petroleum Well Service Engine Maintenance Interval Schedule

C175-16 Locomotive Engine Fuel Control Valve - Remove and Install - Primary

C175-16 Locomotive Engine Flywheel - Remove and Install

C175-16 Locomotive Engine Flow Limiter - Remove and Install

C32 Marine Engines Water Lines

C32 Marine Engines Turbocharger

C32 Marine Engines Water Pump

C32 Marine Engines Water Manifold - Exhaust

C7.1 Industrial Engine Refill Capacities

C32 Marine Engines Flywheel Housing

C175-16 Locomotive Engine Flywheel Housing - Remove and Install

C175-16 Locomotive Engine High Pressure Fuel Rails - Remove and Install

C32 Marine Engines Water Lines

C175-16 Locomotive Engine Temperature Sensor

C7.1 Engines for Caterpillar Built Machines Fuel Priming Pump - Electric Fuel Priming Pump

C175-16 Locomotive Engine Vibration Damper - Remove and Install

C7.1 Industrial Engine Engine Crankcase Breather Element - Replace

C4.4 Industrial Engine Fuel System - Prime

C175-16 Locomotive Engine Fuel Pump (High Pressure) - Remove and Install

C175-16 Locomotive Engine Crankshaft Rear Seal - Remove and Install

C175-16 Locomotive Engine Cooling System Operation

C175-16 Locomotive Engine Air Cleaner - Remove and Install

C175-16 Locomotive Engine Crankshaft Front Seal - Remove and Install

C175-16 Locomotive Engine Turbocharger - Remove and Install