Start By:
- Remove the air cleaners.
- Remove turbo shielding.
- Remove exhaust system.
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
| NOTICE |
|---|
|
Clamp assemblies MUST only be used once. Discard all clamp assemblies after use. |
| NOTICE |
|---|
|
Bellows assemblies MUST only be used once. Discard all bellows assemblies after use. |
- Remove hose assemblies (1).
- Remove tube assembly (2).
Show/hide table
Illustration 2 g03348979 - Disconnect clamps (4) and (5).
- Attach a suitable lifting device to turbocharger (3). The weight of turbocharger (3) is approximately
59 kg (130 lb) Show/hide table
Illustration 3 g03348997 - Remove bolts (6). Remove turbocharger (3).
Show/hide table
Illustration 4 g03349047 - Remove screen assembly (7) from support (9) and inspect. Remove O-ring seal (8).
- Repeat Steps 1 through 6 for the remaining turbochargers.
| |
| Illustration 1 | g03348950 |
Install turbocharger (3) in the reverse order of removal.