Crankshaft Front Seal - Remove and Install
Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 1U-5593 | Drill Bit | 1 |
| B | 1U-7600 | Slide Hammer Puller Gp | 1 |
| C | 250-4587 | Installer | 1 |
| 250-4586 | Locator | 1 | |
| 322-2078 | Bolt | 2 | |
| 9S-8858 | Nut | 1 | |
Start By:
- Remove the vibration damper.
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft front seal.
- Use Tooling (B) in order to remove the outer half of crankshaft front seal (1) .
Show/hide table
 | |
| Illustration 1 | g03348622 |
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft front seal.
- Use Tooling (B) in order to remove the inner half of crankshaft front seal (1) .
Show/hide table
| | |
| Illustration 2 | g03348622 |
Installation Procedure
- Use Tooling (C) to install crankshaft front seal (1) .
Note: Position the locator and install the bolts to hold in position. Install the seal over the locator and position installer. Install nut and turn until the nut stops. Inspect and remove tooling.
Show/hide table
 | |
| Illustration 3 | g03348636 |
End By: Install vibration damper.
Caterpillar Information System:
C175-16 Locomotive Engine Air Cleaner - Remove and Install
C175-16 Locomotive Engine Cooling System Operation
C175-16 Locomotive Engine Crankshaft Rear Seal - Remove and Install
C175-16 Locomotive Engine Fuel Pump (High Pressure) - Remove and Install
C4.4 Industrial Engine Fuel System - Prime
C7.1 Industrial Engine Engine Crankcase Breather Element - Replace
C175-16 Locomotive Engine Vibration Damper - Remove and Install
C7.1 Engines for Caterpillar Built Machines Fuel Priming Pump - Electric Fuel Priming Pump
C175-16 Locomotive Engine Temperature Sensor
C32 Marine Engines Water Lines
C13, C15, and C18 Tier 4 Final Engines Magnetic Pickup
3516C Petroleum Well Service Engine Maintenance Interval Schedule
C175-16 Locomotive Engine Turbocharger - Remove and Install
C18 Locomotive Engines Engine Design
Cam Bearing R&I Tool {0374, 0599, 0700, 0701, 0705, 1201, 1211} Cam Bearing R&I Tool {0374, 0599, 0700, 0701, 0705, 1201, 1211}
C175-16 Locomotive Engine Electronic Unit Injector Sleeve - Remove and Install
C175-16 Locomotive Engine Electronic Unit Injector - Remove and Install
C175-16 Locomotive Engine Cylinder Head - Remove and Install
C175-16 Locomotive Engine Valve Lifter - Remove and Install
C13 Valve Stem Seals Installed Incorrectly{1100, 1101, 7555} C13 Valve Stem Seals Installed Incorrectly{1100, 1101, 7555}
C175-16 Locomotive Engine Rocker Shaft and Push Rods - Remove and Install
374F Excavator Hydraulic System General Information (Pilot System)
C175-16 Locomotive Engine Engine Oil Pan - Disassemble
C175-16 Locomotive Engine Engine Oil Pan - Assemble