Crankshaft Rear Seal - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1U-5593     | Drill Bit     | 1     |
B     | 1U-7600     | Slide Hammer Puller Gp     | 1     |
C     | 250-4587     | Installer     | 1     |
250-4586 | Locator     | 1     | |
322-2078 | Bolt     | 2     | |
9S-8858 | Nut     | 1     |
Start By:
- Remove the flywheel.
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft rear seal.
- Use Tooling (B) in order to remove the outer half of rear crankshaft seal (1) .
Show/hide table
Illustration 1 | g03348412 |
- Use Tooling (A) to drill three evenly spaced holes in the crankshaft rear seal.
- Use Tooling (B) in order to remove the inner half of rear crankshaft seal (1) .
Show/hide table
Illustration 2 | g03348414 |
Installation Procedure
- Use Tooling (C) to install crankshaft rear seal (1) .
Note: Position the locator and install the bolts to hold in position. Install the seal over the locator and position the installer. Install the nut and turn until the nut stops. Inspect and remove the tooling.
Show/hide table
Illustration 3 | g03348423 |
Caterpillar Information System:
C175-16 Locomotive Engine Fuel Pump (High Pressure) - Remove and Install
C4.4 Industrial Engine Fuel System - Prime
C7.1 Industrial Engine Engine Crankcase Breather Element - Replace
C175-16 Locomotive Engine Vibration Damper - Remove and Install
C7.1 Engines for Caterpillar Built Machines Fuel Priming Pump - Electric Fuel Priming Pump
C175-16 Locomotive Engine Temperature Sensor
C32 Marine Engines Water Lines
C13, C15, and C18 Tier 4 Final Engines Magnetic Pickup
3516C Petroleum Well Service Engine Maintenance Interval Schedule
C175-16 Locomotive Engine Fuel Control Valve - Remove and Install - Primary
C175-16 Locomotive Engine Flywheel - Remove and Install
C175-16 Locomotive Engine Flow Limiter - Remove and Install
C175-16 Locomotive Engine Cooling System Operation
C175-16 Locomotive Engine Air Cleaner - Remove and Install
C175-16 Locomotive Engine Crankshaft Front Seal - Remove and Install
C175-16 Locomotive Engine Turbocharger - Remove and Install
C18 Locomotive Engines Engine Design
Cam Bearing R&I Tool {0374, 0599, 0700, 0701, 0705, 1201, 1211} Cam Bearing R&I Tool {0374, 0599, 0700, 0701, 0705, 1201, 1211}
C175-16 Locomotive Engine Electronic Unit Injector Sleeve - Remove and Install
C175-16 Locomotive Engine Electronic Unit Injector - Remove and Install
C175-16 Locomotive Engine Cylinder Head - Remove and Install
C175-16 Locomotive Engine Valve Lifter - Remove and Install
C13 Valve Stem Seals Installed Incorrectly{1100, 1101, 7555} C13 Valve Stem Seals Installed Incorrectly{1100, 1101, 7555}
C175-16 Locomotive Engine Rocker Shaft and Push Rods - Remove and Install