| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Do not open the high pressure fuel system without allowing the fuel system to purge. After the engine has shut down, allow the fuel system to purge for ten minutes. This operating fuel system contains high pressure. Exposure to high pressure fuel can result in personal injury. |
- Use a mirror to remove bolts (2). Remove fuel control valve (1).
Show/hide table
Illustration 2 g01347728 - Check O-ring seals (3), (4), and (5) on fuel control valve (1).
| |
| Illustration 1 | g01347715 |
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | - | Loctite LB 8632 Silicone Lubricant (1) | - |
| - | Loctite LB 8104 Silicone Lubricant (2) | - | |
| - | Loctite LB 8801 Silicone Lubricant (3) | - | |
| - | Loctite LB Superlube (4) | - | |
| (1) | North America |
| (2) | EAME |
| (3) | Asia Pacific Division |
| (4) | South America |
- Apply Tooling (A) to O-ring seals (3), (4), and (5).
- Install O-ring seals (3), (4), and (5) on fuel control valve (1).
Show/hide table
Illustration 4 g01347715 Show/hide table
Illustration 5 g01347742 - Position fuel control valve (1). Install bolts (2). Tighten bolts (2) in the sequence that is shown in Illustration 5.
- Tighten bolts (2) to a torque of
6 N·m (53 lb in) . - Tighten bolts (2) in the sequence that is shown in Illustration 5.
- Tighten bolts (2) to a torque of
12 N·m (106 lb in) .
- Tighten bolts (2) to a torque of
| |
| Illustration 3 | g01347728 |
