Prelubrication Oil Pump - Remove
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
Show/hide table
| 注意 |
|---|
|
在进行检验、保养、测试、调整及维修产品期间，必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前，要准备好合适的容器收集液体。 有关收集和盛接 Cat 产品上油液的适用工具和用品，请参阅专门出版物, NENG2500, "代理商维修工具目录"。 按照当地法规和要求处置所有液体。 |
- 放掉发动机机油。 请参阅操作和保养手册, "发动机机油 - 更换"。
Show/hide table
图 1 g03844954 - 断开软管组件 (1)，卸下螺栓 (2)。
- 拆下螺栓 (4)，并由两个人拆下预润滑油泵 (3)。 预润滑油泵的重量约为
25 kg (55 lb) 。
Caterpillar Information System:
C4.4 and C7.1 Engines Data Link Configuration Status - Test
PM820, PM822, and PM825 Cold Planer Rotor Drive Clutch Bearings - Lubricate
120 and 120 AWD Motor Grader Safety Messages
120 and 120 AWD Motor Grader Monitoring System
C32 Marine Engines Electronic Control Module - Remove and Install - Hazardous Location
G3516 TA Engine Test ECM Mode
3512C Generator Set Engine Auxiliary Water Pump - Remove and Install
3412 Generator Set Sensor Signal (Analog, Passive) - Test
G3600 A4 Engines Nitrogen Oxide Sensor - Calibrate
C15 Generator Set Electronic Modular Control Panel 4 (EMCP 4)
120 and 120 AWD Motor Grader Rollover Protective Structure (ROPS) - Inspect
120 and 120 AWD Motor Grader Secondary Steering - Test
794 AC Off-Highway Truck Field Assembly Platform - Assemble
3512C Generator Set Engine Engine Oil Cooler - Remove and Install
794 AC Off-Highway Truck Field Assembly Stairway - Install
G3500H 50Hz Generator Sets Product Installation
G3500H 50Hz Generator Sets General Maintenance Information
G3500H 50Hz Generator Sets Coolant (NGEC) - Change
G3500H 50Hz Generator Sets Generator Set Alignment - Check - Generator Sets
G3500H 50Hz Generator Sets Overhaul (In-Frame)
3412 Generator Set Sensor Supply - Test
3512C Generator Set Engine Engine Oil Cooler - Disassemble
3512C Generator Set Engine Engine Oil Cooler - Assemble
G3600 A4 Engines Engine Stopping