Engine Oil Cooler - Disassemble
Start By:
- Remove engine oil cooler.
- Remove plug (1).
- Remove bolts (2) and cover (3).
Show/hide table
Illustration 2 g03845104 - Remove oil cooler end hub (4), oil cooler end hub (6), and baffles (5).
Show/hide table
Illustration 1 | g03845088 |
Caterpillar Information System:
3412 Generator Set Sensor Supply - Test
G3500H 50Hz Generator Sets Overhaul (In-Frame)
G3500H 50Hz Generator Sets Generator Set Alignment - Check - Generator Sets
G3500H 50Hz Generator Sets Coolant (NGEC) - Change
G3500H 50Hz Generator Sets General Maintenance Information
G3500H 50Hz Generator Sets Product Installation
794 AC Off-Highway Truck Field Assembly Stairway - Install
3512C Generator Set Engine Engine Oil Cooler - Remove and Install
794 AC Off-Highway Truck Field Assembly Platform - Assemble
G3606 and G3608 Engines Prelubrication Oil Pump - Remove
C4.4 and C7.1 Engines Data Link Configuration Status - Test
PM820, PM822, and PM825 Cold Planer Rotor Drive Clutch Bearings - Lubricate
3512C Generator Set Engine Engine Oil Cooler - Assemble
G3600 A4 Engines Engine Stopping
3512C Generator Set Engine Engine Oil Pump - Remove and Install
G3600 A4 Engines Product Lifting
G3600 A4 Engines Before Starting Engine
G3600 A4 Engines Manual Stop Procedure
G3606 and G3608 Engines Prelubrication Oil Pump - Install
C32 Marine Engines Aftercooler - Remove
C32 Marine Engines Aftercooler - Install
Cat® MineStar System A5:N2 Router Setup and Configuration Guide {7008, 7605} Cat® MineStar System A5:N2 Router Setup and Configuration Guide {7008, 7605}
3412 Generator Set Shutdown - Test
3512C Generator Set Engine Engine Oil Filter Housing - Remove and Install