Engine Oil Cooler - Assemble
- Install baffles (5), oil cooler end hub (6), and oil cooler end hub (4).
Note: Install with large end of taper holes (identified by printed part number) towards outside. Lubricate with Drosera MS220 Waylube and press fit to dimensions shown on both ends.
Show/hide tableIllustration 2 g03845088 - Install cover (3) and bolts (2)
.
- Install plug (1).
Show/hide table
Illustration 1 | g03845104 |
End By:
- Install engine oil cooler.
Caterpillar Information System:
3512C Generator Set Engine Engine Oil Cooler - Disassemble
3412 Generator Set Sensor Supply - Test
G3500H 50Hz Generator Sets Overhaul (In-Frame)
G3500H 50Hz Generator Sets Generator Set Alignment - Check - Generator Sets
G3500H 50Hz Generator Sets Coolant (NGEC) - Change
G3500H 50Hz Generator Sets General Maintenance Information
G3500H 50Hz Generator Sets Product Installation
794 AC Off-Highway Truck Field Assembly Stairway - Install
3512C Generator Set Engine Engine Oil Cooler - Remove and Install
794 AC Off-Highway Truck Field Assembly Platform - Assemble
G3606 and G3608 Engines Prelubrication Oil Pump - Remove
C4.4 and C7.1 Engines Data Link Configuration Status - Test
G3600 A4 Engines Engine Stopping
3512C Generator Set Engine Engine Oil Pump - Remove and Install
G3600 A4 Engines Product Lifting
G3600 A4 Engines Before Starting Engine
G3600 A4 Engines Manual Stop Procedure
G3606 and G3608 Engines Prelubrication Oil Pump - Install
C32 Marine Engines Aftercooler - Remove
C32 Marine Engines Aftercooler - Install
Cat® MineStar System A5:N2 Router Setup and Configuration Guide {7008, 7605} Cat® MineStar System A5:N2 Router Setup and Configuration Guide {7008, 7605}
3412 Generator Set Shutdown - Test
3512C Generator Set Engine Engine Oil Filter Housing - Remove and Install
794 AC Off-Highway Truck Field Assembly Air Lines (Turbocharger) - Install