D350E Series II Articulated Truck Caterpillar

Removal Procedure

1. Park the machine on a hard, level surface. Engage the parking brake and chock the wheels. Turn the disconnect switch to the OFF position.

2. If necessary, raise the suspension and place wood blocks between the frame and the axle.
   Show/hide table

   Illustration 1	g00562633

3. Remove two bolts (1), the washers, and the nuts that secure guard rail (2) to plate (3).
   Show/hide table

   Illustration 2	g00562634

4. Remove bolt (4) and the nut that secures guard rail (2) to fender (5). Remove the guard rail.
   Show/hide table

   Illustration 3	g00562637

5. Install Tooling (A), appropriate nylon lifting straps, and a hoist to fender (5).
   Show/hide table

   Illustration 4	g00562635
   The bolts in this photo are located above the tire inside the wheel well.

6. Remove three bolts (6) at the front of fender (5).
   Show/hide table

   Illustration 5	g00562636

7. Remove bolt (7), the washers, and the nut at the rear of fender (5).
   Show/hide table

   Illustration 6	g00562699
   The bolts in this photo are located inside the wheel well.

8. Remove two bolts (8), the washers, and the nuts that secure fender (5) to the machine. Remove the fender. The weight of the fender is 66 kg (145 lb).

Installation Procedure

1. Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
   Show/hide table

   Illustration 7	g00562637

2. Install Tooling (A), appropriate lifting straps, and a hoist. Place fender (5) into position. The weight of the fender is 66 kg (145 lb).
   Show/hide table

   Illustration 8	g00562699
   The bolts in this photo are located inside the wheel well.

3. Install two bolts (8), the washers, and the nuts that secure fender (5) to the machine.
   Show/hide table

   Illustration 9	g00562636

4. Install bolt (7), the washers, and the nut at the rear of the fender.
   Show/hide table

   Illustration 10	g00562635
   The bolts in this photo are located above the tire inside the wheel well.

5. Install three bolts (6) at the front of fender (5).
   Show/hide table

   Illustration 11	g00562634

6. Place guard rail (2) into position. Install bolt (4) and the nut that secures guard rail (2) to fender (5).
   Show/hide table

   Illustration 12	g00562633

7. Install two bolts (1), the washers, and the nuts that secure guard rail (2) to plate (3).

8. If necessary, remove the wood blocks between the frame and the axle. Adjust the suspension. Refer to Operation and Maintenance Manual, SEBU7064, "Suspension - Lower" for the proper procedure.