65E, 75E, 85E and 95E Agricultural Tractors Caterpillar

Hydraulic Oil Filter (Return) and Base - Remove and Install

Usage:

65E 6GS

Show/hide table

Table 1
Required Tools
Tool	Part Number	Part Description	Qty
A	2P-8250	Strap Wrench Assembly	1

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates.

Show/hide table

Hot oil and components can cause personal injury.

Do not allow hot oil or components to contact skin.

Drain the oil from the hydraulic tank into a suitable container for storage or disposal. The capacity of the hydraulic tank is approximately 110 L (29 US gal). Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the proper draining procedure.

Place an oil pan below the hydraulic oil filter that will be removed. You may lose a small amount of oil when you remove the filter.

Show/hide table

The hydraulic oil filter is located on the right side of the machine. Hydraulic oil filter (1) is located below the cab behind the axle. Access the hydraulic oil filter below the machine. Use Tool (A) to remove hydraulic oil filter (1) .

Show/hide table

Show/hide table

Remove bolts (5) and the washers. Remove bracket (6) and wire (7). Remove the hydraulic oil filter base.

Show/hide table

Show/hide table

Install hydraulic oil filter base (3), bracket (6), and wire (7) with the washers and bolts (5) .

Apply a thin coat of oil to the seal on the filter. Install the filter by hand. When the filter seal contacts the filter base, tighten the filter element by an additional turn of 270 degrees. Rotation marks are spaced at 90 degree intervals. Use these rotation marks as a guide for proper tightening.