D350E Series II Articulated Truck Caterpillar

Accumulator (Suspension) - Remove and Install

Usage:

Removal Procedure

Show/hide table

Table 1
Required Tools
Tool	Part Number	Part Description	Qty
A	6V-2156	Link Bracket	1

Show/hide table

High pressure cylinder. Do not remove any parts until pressure has been relieved or personal injury may occur.

Show/hide table

At operating temperature, the hydraulic tank is hot and under pressure.
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.

Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure.

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat^® products. Dispose of all fluids according to local regulations and mandates.

Park the machine on a hard, level surface. Engage the parking brake and chock the wheels. Turn the disconnect switch to the OFF position.
Put identification marks on all lines, hoses, wires and tubes for installation purposes. Plug all lines, hoses and tubes. This helps prevent fluid loss and contamination of the fluid system.
Purge the pressure from the accumulator. Refer to Testing and Adjusting, RENR3400, "Accumulator (Suspension) - Test and Charge" for the proper procedure.
Show/hide table

Illustration 1 g00567177

Show/hide table

Illustration 2 g00565278
Remove four bolts (1), the washers, two half clamps (2), and hose assembly (3) from suspension accumulator (4). Remove the O-ring.
Remove two bolts (5) and the washers that secure suspension accumulator (4) to the machine.
Show/hide table

Illustration 3 g00565279
Loosen nut (6) on the strap that secures suspension accumulator (4).
Show/hide table

Illustration 4 g00566309
Attach Tooling (A), an appropriate nylon lifting sling, and a hoist to suspension accumulator (4). Remove the suspension accumulator from the machine. The weight of the suspension accumulator is 59 kg (130 lb).

Installation Procedure

Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Lubricate O-ring seals with an appropriate lubricant.
Show/hide table

Illustration 5 g00566309
Attach Tooling (A), an appropriate nylon lifting sling, and a hoist to suspension accumulator (4). Place the suspension accumulator into position. The weight of the suspension accumulator is 59 kg (130 lb).
Show/hide table

Illustration 6 g00565279
Tighten nut (6) on the strap that secures suspension accumulator (4).
Show/hide table

Illustration 7 g00567177
Install two bolts (5) that secure suspension accumulator (4) to the machine.
Position the O-ring and hose assembly (3) to suspension accumulator (4). Install two half clamps (2), four bolts (1), and the washers that secure the hose assembly to the suspension accumulator.
Charge the accumulator. Refer to Testing and Adjusting, RENR3400, "Accumulator (Suspension) - Test and Charge" for the proper procedure.
Check the fluid level in the hoist and brake system tank. Refer to Operation and Maintenance Manual, SEBU7064, "Hoist, Steering, and Brake System Oil Level - Check" for the proper procedure.