D350E Series II Articulated Truck Caterpillar

Installation Procedure

1. Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
   Show/hide table

   Illustration 1	g00589367

2. Use pin (7) and a hammer ,or use a press in order to install bearing (14).
   Show/hide table

   Illustration 2	g00589368

3. Place clamp ring (13) into position. Install six bolts (2).
   Show/hide table

   Illustration 3	g00589371
   This photo was taken at the rear suspension frame.

   Show/hide table

   Illustration 4	g00589374

   Show/hide table

   Illustration 5	g00589373
   This photo was taken at the rear suspension frame.

4. Position the center suspension frame under the machine. Attach Tooling (A) and appropriate nylon lifting slings to each side of the rear of center suspension frame (2).

5. Place the front of the center suspension frame on an appropriate floor jack.

6. Use Tooling (A) and the floor jack in order to raise the frame to the machine. The weight of frame (2) is 187 kg (412 lb).
   Show/hide table

   Illustration 6	g00575864

7. Install six bolts (11) to housing (10).

   Note: It may be necessary to leave the bolts loose until the frame is connected at each point.

   Show/hide table

   Illustration 7	g00589375

8. Use three people or an appropriate lifting device in order to position bracket (9) to the machine. The weight of the bracket is 40 kg (88 lb). Install six bolts (8) and the washers that secure the bracket to housing (10).

   Note: It may be necessary to leave the bolts loose until the frame is connected at each point.

   Show/hide table

   Illustration 8	g00575868

9. Lubricate pin (7). Install the pin. Use a suitable driver in order to install the pin.
   Show/hide table

   Illustration 9	g00575859

   Note: Apply 9S-3263 Thread Lock Compound to the threads of bolt (6).

10. Install bolt (6), the washer, washer (4), nut (5), and the washer.

11. Connect grease line (3) to washer (4).

12. Remove Tooling (A) and the floor jack from the machine.

13. Lubricate pin (7). Use the grease fitting on the bulkhead adapter. The fitting is located at the front of the rear frame. Refer to Operation and Maintenance Manual, SEBU7064, "Suspension and Suspension Cylinder Bearings - Lubricate" for the proper procedure.
    Show/hide table

    Illustration 10	g00589359

14. Install four bolts (1), the washers, the clips, and the nuts that secure the hose assemblies.

End By:

1. Install the center axle stabilizer rod. Refer to Disassembly and Assembly, "Center Axle Stabilizer Rod - Remove and Install".