Front Cover - Remove and Install
Removal Procedure
Start By:
- Remove the accessory drive.
- Remove the vibration damper and the pulley.
- Remove bolts (2) and remove front support (1) .
Show/hide table
Illustration 1 | g02851277 |
- Remove bolts (4) and (5).
Show/hide table
Illustration 2 | g01872517 |
- Remove studs (3), front cover (6), and the gasket.
Installation Procedure
- Install front cover (6) in the reverse order of removal.
- Tighten bolts (2) to a torque of 105 ± 20 N·m (77 ± 14 lb ft).
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Flywheel Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C13 Engine for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Water Pump - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Air Inlet Elbow - Remove and Install
C13 Engine for Caterpillar Built Machines Combustion Head - Remove and Install
C13 Engine for Caterpillar Built Machines Ignition Coil - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Turbocharger - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C13 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (ARD Combustion Air) - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C32 Generator Set General Maintenance Information
2013/06/06 Installing Connecting Rod Bearings in G3600, 3600 and C280 Engines {1225}
Well Service Pumps General Hazard Information
Well Service Pumps Fire Prevention and Explosion Prevention
Well Stimulation Pumps Crushing Prevention and Cutting Prevention
C27 and C32 Generator Sets Product Installation