Flywheel - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | FT-2712     | Guide Stud     | 2     |
- Remove two of bolts (1) and install Tooling (A).
Show/hide table
Illustration 1 | g01871015 |
- Use two people to remove flywheel (2). The weight of flywheel (2) is approximately 41 kg (90 lb). Remove remaining bolts (1) and flywheel (2) .
- Use a hammer and a punch in order to remove the ring gear.
Installation Procedure
- Install flywheel (2) in reverse order of removal.
- Raise the temperature of the ring gear. Use a soft hammer in order to seat the ring gear on the flywheel.
- Tighten bolts (1) to a torque of 300 ± 40 N·m (221 ± 30 lb ft).
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Water Pump - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Air Inlet Elbow - Remove and Install
C13 Engine for Caterpillar Built Machines Combustion Head - Remove and Install
C13 Engine for Caterpillar Built Machines Ignition Coil - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Turbocharger - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove and Install
Instructions for Determining Failed Active Power Module (APM) Inverter on Certain Uninterruptible Power Supplies{1418, 4822} Instructions for Determining Failed Active Power Module (APM) Inverter on Certain Uninterruptible Power Supplies{1418, 4822}
C13 Engine for Caterpillar Built Machines Flywheel Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Front Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C13 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (ARD Combustion Air) - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C32 Generator Set General Maintenance Information
2013/06/06 Installing Connecting Rod Bearings in G3600, 3600 and C280 Engines {1225}
Well Service Pumps General Hazard Information
Well Service Pumps Fire Prevention and Explosion Prevention