Pressure Sensor (ARD Combustion Air) - Remove and Install
Removal Procedure
- Disconnect the harness assembly from pressure sensor (1) and remove pressure sensor (1) .
Show/hide table
Illustration 1 | g02860045 |
Installation Procedure
- Install pressure sensor (1) in the reverse order of removal.
- Tighten pressure sensor (3) to a torque of 10 ± 2 N·m (89 ± 18 lb in).
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
C13 Engine for Caterpillar Built Machines Front Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Flywheel Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C13 Engine for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Water Pump - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Air Inlet Elbow - Remove and Install
C13 Engine for Caterpillar Built Machines Combustion Head - Remove and Install
C13 Engine for Caterpillar Built Machines Ignition Coil - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C32 Generator Set General Maintenance Information
2013/06/06 Installing Connecting Rod Bearings in G3600, 3600 and C280 Engines {1225}
Well Service Pumps General Hazard Information
Well Service Pumps Fire Prevention and Explosion Prevention
Well Stimulation Pumps Crushing Prevention and Cutting Prevention
C27 and C32 Generator Sets Product Installation
Well Stimulation Pumps Before Operation
Well Service Pumps Operation
Well Stimulation Pumps Safety Messages
Well Stimulation Pumps Pump (Fluid End) Plunger Lube Oil Level - Check