Flywheel Housing - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7574     | Link Brackets     | 2     |
B     | 8C-8422     | Sealant     | -     |
Start By:
- Remove the flywheel.
- Remove the crankshaft rear seal.
- If necessary, remove fuel filter base (1) and reposition fuel filter base (1). Remove bracket (2) .
Show/hide table
Illustration 1 | g02175589 |
- If necessary, remove oil filter base (3) and reposition oil filter base (3). Remove bracket (4) .
Show/hide table
Illustration 2 | g01870417 |
- Install Tooling (A) and a suitable lifting device to flywheel housing (6). The weight of flywheel housing (6) is approximately 64 kg (140 lb). Remove bolts (5) and flywheel housing (6) .
Show/hide table
Illustration 3 | g01870418 |
Installation Procedure
- Install flywheel housing (6) in the reverse order of removal.
- Apply Tooling (B) to the backside of flywheel housing (6). Install within 10 minutes of application.
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C13 Engine for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Water Pump - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Air Inlet Elbow - Remove and Install
C13 Engine for Caterpillar Built Machines Combustion Head - Remove and Install
C13 Engine for Caterpillar Built Machines Ignition Coil - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Turbocharger - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove and Install
C13 Engine for Caterpillar Built Machines Front Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Gear - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C13 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (ARD Combustion Air) - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C32 Generator Set General Maintenance Information
2013/06/06 Installing Connecting Rod Bearings in G3600, 3600 and C280 Engines {1225}
Well Service Pumps General Hazard Information
Well Service Pumps Fire Prevention and Explosion Prevention
Well Stimulation Pumps Crushing Prevention and Cutting Prevention