Camshaft Gear - Remove and Install
Removal Procedure
Start By:
- Remove the camshaft.
- Wrap the camshaft with a protective covering in order to prevent damage to the camshaft.
- Use a suitable press to remove drive gear (1) from camshaft (3) .
Show/hide table
Illustration 1 | g00522082 |
Show/hide table
NOTICE |
---|
Do not allow the camshaft to fall to the floor when pressing it from the drive gear. Also make sure that the camshaft lobes do not catch on the press plates. |
- Remove woodruff key (2) .
Installation Procedure
- Install drive gear (1) in the reverse order of removal.
- Raise the temperature of drive gear (1) to a temperature of 315° C (600° F).
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Front Cover - Remove and Install
C13 Engine for Caterpillar Built Machines Flywheel Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Flywheel - Remove and Install
C13 Engine for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Water Pump - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
C13 Engine for Caterpillar Built Machines Air Inlet Elbow - Remove and Install
C13 Engine for Caterpillar Built Machines Combustion Head - Remove and Install
C13 Engine for Caterpillar Built Machines Ignition Coil - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Turbocharger - Remove and Install
C13 Engine for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C13 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (ARD Combustion Air) - Remove and Install
C13 Engine for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Engine for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
C32 Generator Set General Maintenance Information
2013/06/06 Installing Connecting Rod Bearings in G3600, 3600 and C280 Engines {1225}
Well Service Pumps General Hazard Information
Well Service Pumps Fire Prevention and Explosion Prevention
Well Stimulation Pumps Crushing Prevention and Cutting Prevention
C27 and C32 Generator Sets Product Installation
Well Stimulation Pumps Before Operation