Throttle Control Valve - Remove
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 138-7573 | Link Bracket | 4 |
Start By:
- Remove the fuel control actuator. Refer to Disassembly and Assembly, "Fuel Control Actuator - Remove and Install".
- Turn the mode switch to OFF/RESET for the gas supply.
Show/hide table
Illustration 1 g01699778 - Disconnect the harness assembly.
- Attach Tooling (A) and a suitable lifting device to throttle (1).
- Remove bolts (3) and the washers.
- Remove elbow (4) from adapter (5) and the O-ring seal.
- Remove bolts (2) and the washers.
- Remove throttle (1) and the gasket. The weight of throttle (1) is approximately
23 kg (51 lb) .
Caterpillar Information System:
C18 Fire Pump Industrial Engine Heat Exchanger - Disassemble
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Speed Sensor (Transmission) - Engine Output
2009/02/16 New Software and a New Rotary Switch Improve the Reliability of the Engine Speed Dial on Excavators {1408, 7332, 7610, 7620}
C175 Generator Sets Fuel System - Prime
C18 Fire Pump Industrial Engine Heat Exchanger - Install
3612 and 3616 Engines Air Shutoff
G3500B Engines Electrical Connectors
C18 Fire Pump Industrial Engine Heat Exchanger - Remove
C18 Fire Pump Industrial Engine Expansion Tank - Remove and Install
C18 Fire Pump Industrial Engine Air Cleaner - Remove and Install
C18 Fire Pump Industrial Engine Alternator - Remove and Install
G3516 Petroleum Engines Fuel Control Actuator - Remove and Install
C15 Petroleum Engines Timing - Calibrate
G3516 Petroleum Engines Throttle Control Valve - Install
Information for the New Flame Detection Temperature Sensors{108B, 108E, 108M} Information for the New Flame Detection Temperature Sensors{108B, 108E, 108M}
3500 Generator Sets Zinc Rods - Inspect/Replace
3000 Frame SR5 Electric Power Generation Terminal Box - Remove and Install
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Vibration Damper
C175 Generator Sets Engine Operation
C175 Generator Sets Electronic Modular Control Panel 3 (EMCP 3)
2008/10/27 Replace the Two-Piece Piston if the Piston Contacts a Valve {1225}
3612 and 3616 Engines Piston and Rings - Three Ring Piston
3512, 3508 and 3516 Generator Sets Safety Messages
3500 Generator Sets Safety Messages