Heat Exchanger - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7573     | Link Bracket     | 2     |
- Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
- Disconnect clamp assemblies (1) and disconnect tube assemblies (2) .
Show/hide table
Illustration 1 | g01697036 |
- Disconnect hoses (3) .
- Remove U-bolts (4) from heat exchanger (5) .
- Attach Tooling (A) and a suitable lifting device onto the heat exchanger. The weight of the heat exchanger is approximately 64 kg (140 lb).
Show/hide table
Illustration 2 | g01697533 |
- Remove the heat exchanger.
Caterpillar Information System:
C18 Fire Pump Industrial Engine Expansion Tank - Remove and Install
C18 Fire Pump Industrial Engine Air Cleaner - Remove and Install
C18 Fire Pump Industrial Engine Alternator - Remove and Install
G3516 Petroleum Engines Fuel Control Actuator - Remove and Install
C18 Fire Pump Industrial Engine Electronic Control Module - Remove and Install
Winding Insulation Maintenance and Cleaning and Drying of the Generators {4450} Winding Insulation Maintenance and Cleaning and Drying of the Generators {4450}
2008/12/15 A New Pressure Gauge Is Now Used. {7456}
2008/10/27 A New Heat Shield for the Exhaust Manifold is Available {1067}
C6.6 Marine Generator Set Engine Design
C18 Fire Pump Industrial Engine Turbocharger Outlet Pressure Sensor - Remove and Install
3512B SR4B Generator Sets Radiator - Clean
C18 Fire Pump Industrial Engine Inlet Air Temperature Sensor - Remove and Install
G3500B Engines Electrical Connectors
3612 and 3616 Engines Air Shutoff
C18 Fire Pump Industrial Engine Heat Exchanger - Install
C175 Generator Sets Fuel System - Prime
2009/02/16 New Software and a New Rotary Switch Improve the Reliability of the Engine Speed Dial on Excavators {1408, 7332, 7610, 7620}
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Speed Sensor (Transmission) - Engine Output
C18 Fire Pump Industrial Engine Heat Exchanger - Disassemble
G3516 Petroleum Engines Throttle Control Valve - Remove
C15 Petroleum Engines Timing - Calibrate
G3516 Petroleum Engines Throttle Control Valve - Install
Information for the New Flame Detection Temperature Sensors{108B, 108E, 108M} Information for the New Flame Detection Temperature Sensors{108B, 108E, 108M}
3500 Generator Sets Zinc Rods - Inspect/Replace