Electronic Control Module - Remove and Install
Removal Procedure
- Disconnect the negative battery terminal at the battery.
- Loosen allen head screws (1). Disconnect the harness assemblies from electronic control module (2) .
Show/hide table
Illustration 1 | g01694693 |
- Remove bolts (3) .
Show/hide table
Illustration 2 | g01694714 |
- Remove electronic control module (2) and remove the isolation mounts.
- Remove supports (4) and remove the inboard electronic control module.
Installation Procedure
- Position isolation mounts on the inboard electronic control module.
Show/hide table
Illustration 3 | g01694714 |
- Position the inboard electronic control module and install supports (4) .
- Position the isolation mounts on electronic control module (2) and install the electronic control module.
- Install bolts (3) .
- Connect the harness assemblies to electronic control module (2). Tighten bolts (1) to a torque of 6 ± 1 N·m (53 ± 9 lb in). Repeat this step for the inboard electronic control module.
Show/hide table
Illustration 4 | g01694693 |
- Connect the negative battery terminal at the battery.
Caterpillar Information System:
Winding Insulation Maintenance and Cleaning and Drying of the Generators {4450} Winding Insulation Maintenance and Cleaning and Drying of the Generators {4450}
2008/12/15 A New Pressure Gauge Is Now Used. {7456}
2008/10/27 A New Heat Shield for the Exhaust Manifold is Available {1067}
C6.6 Marine Generator Set Engine Design
C18 Fire Pump Industrial Engine Turbocharger Outlet Pressure Sensor - Remove and Install
3512B SR4B Generator Sets Radiator - Clean
C18 Fire Pump Industrial Engine Inlet Air Temperature Sensor - Remove and Install
PM3516 Power Modules Refill Capacities and Recommendations
2009/01/26 Improved Fuel Injection Pump Timing Tool {1251}
C18 Fire Pump Industrial Engine Valve Mechanism Cover - Remove and Install
C18 Fire Pump Industrial Engine Housing (Front) - Install
C18 Fire Pump Industrial Engine Housing (Front) - Remove
G3516 Petroleum Engines Fuel Control Actuator - Remove and Install
C18 Fire Pump Industrial Engine Alternator - Remove and Install
C18 Fire Pump Industrial Engine Air Cleaner - Remove and Install
C18 Fire Pump Industrial Engine Expansion Tank - Remove and Install
C18 Fire Pump Industrial Engine Heat Exchanger - Remove
G3500B Engines Electrical Connectors
3612 and 3616 Engines Air Shutoff
C18 Fire Pump Industrial Engine Heat Exchanger - Install
C175 Generator Sets Fuel System - Prime
2009/02/16 New Software and a New Rotary Switch Improve the Reliability of the Engine Speed Dial on Excavators {1408, 7332, 7610, 7620}
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Speed Sensor (Transmission) - Engine Output
C18 Fire Pump Industrial Engine Heat Exchanger - Disassemble