Zinc Rods - Inspect/Replace
锌棒必须在适当的周期进行检查。 锌棒必须在出现损蚀时予以更换。
Show/hide table
图 1 | g01700317 |
热交换器有三个锌棒。 |
在用海水加注铅管的最初 24 小时内,检查锌棒。 如果没有发现明显的腐蚀,在发动机运转七天或 50 小时后以及浸放在海水中后,再次检查锌棒。 如果没有发现明显的变质,在发动机每运转 50 小时后,继续进行检查。
- 锌棒为红色,便于识别。 拆下锌棒。
Show/hide table
图 2 g00104048 - 用锤子轻微敲击锌棒。 如果锌棒已经损蚀,或锌棒成片剥落的话,应安装新锌棒。
Caterpillar Information System:
Information for the New Flame Detection Temperature Sensors{108B, 108E, 108M} Information for the New Flame Detection Temperature Sensors{108B, 108E, 108M}
G3516 Petroleum Engines Throttle Control Valve - Install
C15 Petroleum Engines Timing - Calibrate
G3516 Petroleum Engines Throttle Control Valve - Remove
C18 Fire Pump Industrial Engine Heat Exchanger - Disassemble
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Speed Sensor (Transmission) - Engine Output
2009/02/16 New Software and a New Rotary Switch Improve the Reliability of the Engine Speed Dial on Excavators {1408, 7332, 7610, 7620}
C175 Generator Sets Fuel System - Prime
C18 Fire Pump Industrial Engine Heat Exchanger - Install
3612 and 3616 Engines Air Shutoff
G3500B Engines Electrical Connectors
C18 Fire Pump Industrial Engine Heat Exchanger - Remove
3000 Frame SR5 Electric Power Generation Terminal Box - Remove and Install
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Vibration Damper
C175 Generator Sets Engine Operation
C175 Generator Sets Electronic Modular Control Panel 3 (EMCP 3)
2008/10/27 Replace the Two-Piece Piston if the Piston Contacts a Valve {1225}
3612 and 3616 Engines Piston and Rings - Three Ring Piston
3512, 3508 and 3516 Generator Sets Safety Messages
3500 Generator Sets Safety Messages
120K Motor Grader Backup Alarm
C18 Fire Pump Industrial Engine Heat Exchanger - Assemble
2008/12/22 A New Turbocharger Cartridge is Used {1052, 1053}
120K Motor Grader Hydraulic System Oil Level - Check