C32 Marine Engines Caterpillar


Rocker Arm and Shaft - Remove

Usage:

C32 AX2

拆卸步骤

表 1
所需工具 
工具  零件号  零件描述  数量 
124-2946  提升支架 

开始:

  1. 拆下气门机构盖。 请参阅拆解和组装, "气门机构盖 - 拆卸和安装"。


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损並縮短部件使用寿命。




    图 1g01188378

  1. 拆下螺栓 (2 )。

  2. 使用工具 (A) 将摇臂轴组件 (4)、气门摇臂 (3) 和电子单体喷油器摇臂 (1) 作为一个整体拆下。

Caterpillar Information System:

C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Valve Mechanism Cover Base - Remove and Install
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C32 Marine and Auxiliary Marine Engines Valve Mechanism Cover - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Install
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Muffler - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Remove
C13 Engine for Combat and Tactical Vehicles Engine Design
C-12 Generator Set Engine CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
C9-XQ300 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C32 Marine Engines Rocker Arm and Shaft - Install
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C11 and C13 On-Highway Engines Turbocharger
C11 and C13 On-Highway Engines Air Lines
C27 and C32 Generator Set Engines Flywheel
C11 and C13 On-Highway Engines Camshaft
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3126B Generator Set Engine Diagnostic Codes
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.