Valve Mechanism Cover Base - Remove and Install
开始:
- 拆下气门机构盖。 请参阅拆解和组装, "气门机构盖 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 断开线束组件 (3) 和线束组件 (2)。
- 拆下螺栓 (4)。
- 从缸盖上卸下气门机构盖底座 (1) 和密封件。
Show/hide table
图 1 | g01188292 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 将密封件安装到气门机构盖底座 (1) 上。
- 将气门机构盖底座 (1) 安置在缸盖上,安装螺栓 (4)。
- 将线束组件 (3) 安置在电子单体喷油器上。 拧紧盖螺母至扭矩为
1.70 ± 0.25 N·m (15 ± 2 lb in) 。 - 连接线束组件 (2)。
Show/hide table
图 2 | g01188292 |
结束:
- 安装气门机构盖。 请参阅拆解和组装, "气门机构盖 - 拆卸和安装"。
Caterpillar Information System:
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C32 Marine and Auxiliary Marine Engines Valve Mechanism Cover - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Install
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Muffler - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Remove
C13 Engine for Combat and Tactical Vehicles Engine Design
C-12 Generator Set Engine CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
G3408C and G3412C Engines Inlet and Exhaust Valve Guides - Remove and Install - New Taller Head
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 05
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Rocker Arm and Shaft - Remove
C9-XQ300 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C32 Marine Engines Rocker Arm and Shaft - Install
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C11 and C13 On-Highway Engines Turbocharger
C11 and C13 On-Highway Engines Air Lines
C27 and C32 Generator Set Engines Flywheel
C11 and C13 On-Highway Engines Camshaft
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System