Air Lines
Show/hide table
 |
波纹管的末端很锋利。 如果波纹管处理不妥当，可能会发生伤害。 通过波纹部位拿住波纹管。 |
Show/hide table
| 注意 |
|---|
波纹管的定位很重要。 不正确的定位会导致波纹管过早损坏。 目视检查波纹压缩是否一致，来判断是否定位好。 安装之前，检查波纹管是否有损伤。 如果波纹有任何损坏，废弃此波纹管。 波纹管口的微小破损可以修复。 然而，如果修理后安装有任何困难，废弃此波纹管。 |
Show/hide table
| 图 1 | g01188536 |
发动机右侧 | |
(1) 带形卡箍扭矩 ... 8 ± 3 N·m (70 ± 27 lb in)
(2) 进气弯头
注: 有关进气弯头卡箍的正确方位，请参考图 1。
Caterpillar Information System:
C11 and C13 On-Highway Engines Turbocharger
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C32 Marine Engines Rocker Arm and Shaft - Install
C9-XQ300 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C32 Marine Engines Rocker Arm and Shaft - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Valve Mechanism Cover Base - Remove and Install
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C32 Marine and Auxiliary Marine Engines Valve Mechanism Cover - Remove and Install
C27 and C32 Generator Set Engines Flywheel
C11 and C13 On-Highway Engines Camshaft
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3126B Generator Set Engine Diagnostic Codes
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
C11 and C13 Industrial Engines Engine Oil Filter Base
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
C11 and C13 On-Highway Engines Engine Oil Cooler
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 05
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 06