Flywheel
Show/hide table
Illustration 1 | g01188636 |
(1) Flywheel gear
(2) Flywheel |
Note: Refer to Systems Operation/Testing and Adjusting for the correct method for flywheel runout and flywheel inspection.
Note: Replace the twelve bolts (3) at service.
- Apply 6V-4876 Lubricant to the threads of the bolts (3) before assembly.
Note: Tighten the twelve bolts in a circular pattern. The circular pattern can be in a clockwise direction or in a counterclockwise direction.
- Torque each bolt to
100 ± 5 N·m (75 ± 4 lb ft) .Note: Tighten the twelve bolts again with the circular pattern that was used in Step 2.
- Turn each bolt by an additional 180 ± 5 degrees.
Caterpillar Information System:
C11 and C13 On-Highway Engines Air Lines
C11 and C13 On-Highway Engines Turbocharger
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C32 Marine Engines Rocker Arm and Shaft - Install
C9-XQ300 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C32 Marine Engines Rocker Arm and Shaft - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Valve Mechanism Cover Base - Remove and Install
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C11 and C13 On-Highway Engines Camshaft
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3126B Generator Set Engine Diagnostic Codes
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
C11 and C13 Industrial Engines Engine Oil Filter Base
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
C11 and C13 On-Highway Engines Engine Oil Cooler
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 05
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 06
2005/12/01 Improved Valve Springs are Now Used {1100, 1108}