Engine Speed/Timing Sensors - Check/Clean/Calibrate
Show/hide table
| |
| Illustration 1 | g01183578 |
- Remove the bolt that retains the bracket for the speed/timing sensors from the front housing. Check the condition of the speed/timing sensors for wear and/or contaminants.
- Clean the metal shavings and other debris from the speed/timing sensors.
- Install the engine speed/timing sensors and the bracket. Tighten the bolt for the bracket to a torque of
28 ± 7 N (6.2947 ± 1.5737 lb) .
Refer to the Specifications Manual for more information on the speed/timing sensors.
Caterpillar Information System:
C32 Marine Engines Rocker Arm and Shaft - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Valve Mechanism Cover Base - Remove and Install
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C32 Marine and Auxiliary Marine Engines Valve Mechanism Cover - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Install
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Muffler - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Remove
C13 Engine for Combat and Tactical Vehicles Engine Design
C32 Marine Engines Rocker Arm and Shaft - Install
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C11 and C13 On-Highway Engines Turbocharger
C11 and C13 On-Highway Engines Air Lines
C27 and C32 Generator Set Engines Flywheel
C11 and C13 On-Highway Engines Camshaft
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3126B Generator Set Engine Diagnostic Codes
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
C11 and C13 Industrial Engines Engine Oil Filter Base