Camshaft
Show/hide table
 | |
| 图 1 | g01188644 |
(1) 凸轮轴轴承轴颈直径 ... 77.850 ± 0.025 mm
(3.0650 ± 0.0010 in)
凸轮旋转角度为 0 时，喷射器用的凸轮轴上的凸轮有最大提升。 ... 12.703 mm
(0.5001 in)
凸轮旋转角度为 0 时，喷射器用的凸轮轴上的凸轮有最大提升。 ... 74 度到 254 度
喷油器凸轮提升高度为 5.238 mm
(0.2062 in) 时，凸轮轴应有旋转角度。 ... 35 ± 0.25 度
(2) 螺栓
- 螺栓扭矩 ... 35 ± 8 N·m (26 ± 6 lb ft)
Caterpillar Information System:
C27 and C32 Generator Set Engines Flywheel
C11 and C13 On-Highway Engines Air Lines
C11 and C13 On-Highway Engines Turbocharger
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C32 Marine Engines Rocker Arm and Shaft - Install
C9-XQ300 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C32 Marine Engines Rocker Arm and Shaft - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Valve Mechanism Cover Base - Remove and Install
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3126B Generator Set Engine Diagnostic Codes
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
C11 and C13 Industrial Engines Engine Oil Filter Base
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
C11 and C13 On-Highway Engines Engine Oil Cooler
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 05
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 06
2005/12/01 Improved Valve Springs are Now Used {1100, 1108}
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 03