Turbocharger
Show/hide table
图 1 | g01188495 |
(1) 管组件
- 将管组件螺母拧紧至以下扭矩。 ... 12 ± 1.5 N·m (106 ± 13 lb in)
(2) 安装涡轮增压机用的螺母
- 组装之前,将 5P-3931 防咬合剂 (高温型)涂抹到涡轮增压机的安装螺柱的垫圈表面和螺纹上。 将固定涡轮增压器到排气歧管上的螺栓和螺母拧紧至以下扭矩。 ... 70 ± 15 N·m (52 ± 11 lb ft)
(3) 螺柱
- 将螺柱拧紧至以下扭矩。 ... 35 ± 5 N·m (26 ± 4 lb ft)
注: 安装螺母,使冲压字母 X 能够露出。
Caterpillar Information System:
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Exhaust Manifold - Remove and Install
C32 Marine Engines Rocker Arm and Shaft - Install
C9-XQ300 Rental Generator Set Engine Speed/Timing Sensors - Check/Clean/Calibrate
C32 Marine Engines Rocker Arm and Shaft - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
C32 Marine Engines Valve Mechanism Cover Base - Remove and Install
3412E and C30 Marine Engines Fuel System Water Separator - Drain
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 1779 FMI 06
C4.4 and C6.6 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
C32 Marine and Auxiliary Marine Engines Valve Mechanism Cover - Remove and Install
C32 Marine and Auxiliary Marine Engines Housing (Rear) - Install
C11 and C13 On-Highway Engines Air Lines
C27 and C32 Generator Set Engines Flywheel
C11 and C13 On-Highway Engines Camshaft
C15 Petroleum Generator Set Engines Alternator and Regulator
2005/08/15 New Bolt Available to Secure Generator Flex-Plate to Generator Rotor Shaft {3252}
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3126B Generator Set Engine Diagnostic Codes
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
C11 and C13 Industrial Engines Engine Oil Filter Base
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
C11 and C13 On-Highway Engines Engine Oil Cooler
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 05