Lifter Group
Show/hide table
 | |
| Illustration 1 | g00988934 |
Clearance between the lifter and the bore in the engine for the lifter
- Standard at assembly ... 0.016 to 0.052 mm (0.0006 to 0.0020 inch)
- Repair limit ... 0.08 mm (0.0031 inch)
Caterpillar Information System:
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Alternator and Regulator
3500B and 3500C Marine Propulsion Engines Engine Speed/Timing Sensor - Calibrate
C7 Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
3500B and 3500C Marine Propulsion Engines Secondary ECM/Personality Module
3500B and 3500C Marine Propulsion Engines Starting Motor System
3500B Series II Marine Engines Prelubrication System
3500B and 3500C Marine Propulsion Engines Injector Solenoids
3500B and 3500C Marine Propulsion Engines Engine Speed/Timing Sensor
3500B and 3500C Marine Propulsion Engines Engine Control Switch (ECS)
C7 Engines for Caterpillar Built Machines Unit Injector Sleeve - Remove
3500B and 3500C Marine Propulsion Engines Emergency Stop Switch
3500B and 3500C Marine Propulsion Engines Electrical Power Supply
G3304 and G3306 Engines Camshaft - Remove
Cold Weather Recommendations for On-Highway Diesel Truck Engines Fuel System Information
3618 Engine After Stopping Engine
G3304 and G3306 Engines Camshaft - Install
G3500B Engines Compressor Bypass
G3500C and G3500E Generator Set Engines Compressor Bypass - Adjust
G3500B Engines Electronic Control System Operation
C7 On-highway Engine Air Inlet Cover - Remove and Install
G3304 and G3306 Engines Timing Gear Cover - Remove and Install
3044C Industrial Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
C7 On-Highway Engine Crankshaft Rear Seal - Remove
G3304 and G3306 Engines Timing Gears - Remove