Air Inlet Cover - Remove and Install
Removal Procedure
- Disconnect harness assembly (1), harness assembly (2), and harness assembly (3) .
Show/hide table
Illustration 1 | g01030042 |
- Remove tube assembly (4) .
- Remove bolts (6) and remove air inlet cover (5) .
Show/hide table
Illustration 2 | g01031440 |
Installation Procedure
Note: Check the condition of all the gaskets. If necessary, replace the gaskets.
- Position air inlet cover (5) on the engine. Install bolts (6) .
Show/hide table
Illustration 3 | g01031440 |
- Install tube assembly (4) .
Show/hide table
Illustration 4 | g01030042 |
- Connect harness assembly (1), harness assembly (2), and harness assembly (3) .
Caterpillar Information System:
G3500B Engines Electronic Control System Operation
G3500C and G3500E Generator Set Engines Compressor Bypass - Adjust
G3500B Engines Compressor Bypass
G3304 and G3306 Engines Camshaft - Install
3618 Engine After Stopping Engine
Cold Weather Recommendations for On-Highway Diesel Truck Engines Fuel System Information
G3304 and G3306 Engines Camshaft - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Lifter Group
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Alternator and Regulator
3500B and 3500C Marine Propulsion Engines Engine Speed/Timing Sensor - Calibrate
C7 Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
3500B and 3500C Marine Propulsion Engines Secondary ECM/Personality Module
G3304 and G3306 Engines Timing Gear Cover - Remove and Install
3044C Industrial Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
C7 On-Highway Engine Crankshaft Rear Seal - Remove
G3304 and G3306 Engines Timing Gears - Remove
G3500B Engines Start/Stop Control
3516B and 3516B HD Engines and 994D, 994F, and 994H Wheel Loaders Camshaft
C15 On-Highway Engines Electronic Unit Injector - Adjust
G3304 and G3306 Engines Timing Gears - Install
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install