Timing Gears - Install
Show/hide table
Required Tools | |||
Tooling | Part Number | Description | Qty |
A | 1P-0510 | Driver | 1 |
- Install camshaft drive gear (1). Ensure that the "C" label on the crankshaft gear is in alignment with the "C" label on camshaft drive gear (1).
- Install the four bolts that hold camshaft drive gear (1).
Show/hide table
Illustration 2 g00989162 - Use Tooling (A) in order to install the bearing in idler gear (2).
Show/hide table
Illustration 3 g00989163 - Place idler gear (2) in position on shaft (3). Place the machined side of the plate toward the gear. Fasten the place with two bolts.
Show/hide table
Illustration 4 g00989166 - Place magneto drive gear (4) in position over magneto drive shaft (5).
- Install the washer with the chamfered edge away from the gear. Fasten the washer with the bolt. Tighten the bolt to a torque of
150 ± 7 N·m (110 ± 5 lb ft) .
Show/hide table
Illustration 1 | g00989161 |
End By:
- Install the timing gear cover. Refer to Disassembly and Assembly, "Timing Gear Cover - Remove and Install" for the engine that is being serviced.
Caterpillar Information System:
C15 On-Highway Engines Electronic Unit Injector - Adjust
3516B and 3516B HD Engines and 994D, 994F, and 994H Wheel Loaders Camshaft
G3500B Engines Start/Stop Control
G3304 and G3306 Engines Timing Gears - Remove
C7 On-Highway Engine Crankshaft Rear Seal - Remove
3044C Industrial Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
G3304 and G3306 Engines Timing Gear Cover - Remove and Install
C7 On-highway Engine Air Inlet Cover - Remove and Install
G3500B Engines Electronic Control System Operation
G3500C and G3500E Generator Set Engines Compressor Bypass - Adjust
G3500B Engines Compressor Bypass
G3304 and G3306 Engines Camshaft - Install
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C7 On-Highway Engine Speed/Timing Sensor - Remove and Install
G3304 and G3306 Engines Timing Gear Plate - Remove and Install
C7 On-Highway Engine Boost Pressure Sensor - Remove and Install
C7 and C9 On-Highway Engines Intermittent Low Power or Power Cutout
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
G3500B Engines Engine Governing
C7 On-Highway Engine Housing (Front) - Remove
C7 On-Highway Engine Unit Injector Hydraulic Pump - Install