Timing Gears - Remove
Show/hide table
Required Tools | |||
Tooling | Part Number | Description | Qty |
A | 8S-2264 | Puller | 1 |
9S-9155 | Spacer | 1 | |
- | Bolt (3/8 inch - 24 NF x 3 1/4 inch) | 2 | |
- | Flat Washer | 2 | |
B | 1P-0510 | Driver | 1 |
C | 1P-2321 | Combination Puller | 1 |
Start By:
- Remove the timing gear cover. Refer to Disassembly and Assembly, "Timing Gear Cover - Remove" for the engine that is being serviced.
- Turn the crankshaft until No. 1 piston is at TOP DEAD CENTER position and the "C" mark on the crankshaft gear is in alignment with the "C" mark on the camshaft gear, as shown.
Show/hide table
Illustration 2 g00989119 - Remove bolt (2) and the washer from magneto drive gear (1).
Show/hide table
Illustration 3 g00989122 - Install Tooling (A) on magneto drive gear (1). Use Tooling (A) in order to remove magneto drive gear (1) from the magneto drive shaft.
Show/hide table
Illustration 4 g00989123 - Remove two bolts (3) and the plate.
- Remove idler gear (2).
- Remove four bolts (4) from the camshaft gear.
Show/hide table
Illustration 5 g00989128 - Use Tooling (B) in order to remove the bearing from idler gear (2).
Show/hide table
Illustration 6 g00989130 - Install Tooling (C) on camshaft gear (5).
- Use Tooling (C) in order to carefully remove camshaft gear (5).
Show/hide table
Illustration 1 | g00989118 |
Caterpillar Information System:
C7 On-Highway Engine Crankshaft Rear Seal - Remove
3044C Industrial Engine Cooling System Supplemental Coolant Additive (SCA) - Test/Add
G3304 and G3306 Engines Timing Gear Cover - Remove and Install
C7 On-highway Engine Air Inlet Cover - Remove and Install
G3500B Engines Electronic Control System Operation
G3500C and G3500E Generator Set Engines Compressor Bypass - Adjust
G3500B Engines Compressor Bypass
G3304 and G3306 Engines Camshaft - Install
3618 Engine After Stopping Engine
Cold Weather Recommendations for On-Highway Diesel Truck Engines Fuel System Information
G3304 and G3306 Engines Camshaft - Remove
3044C Industrial Engine and Engines for Caterpillar Built Machines Lifter Group
G3500B Engines Start/Stop Control
3516B and 3516B HD Engines and 994D, 994F, and 994H Wheel Loaders Camshaft
C15 On-Highway Engines Electronic Unit Injector - Adjust
G3304 and G3306 Engines Timing Gears - Install
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C7 On-Highway Engine Speed/Timing Sensor - Remove and Install
G3304 and G3306 Engines Timing Gear Plate - Remove and Install
C7 On-Highway Engine Boost Pressure Sensor - Remove and Install
C7 and C9 On-Highway Engines Intermittent Low Power or Power Cutout