Housing (Front) - Remove
Start By:
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
- Remove the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Remove".
- Remove the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Support the weight of the front of the engine. Remove bolts (1) and remove front engine support (2).
Show/hide table
Illustration 2 g01125215 - Remove bolts (3) and (5). Remove front housing (4).
Show/hide table
| |
| Illustration 1 | g00989343 |
Caterpillar Information System:
G3500B Engines Engine Governing
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C7 and C9 On-Highway Engines Intermittent Low Power or Power Cutout
C7 On-Highway Engine Boost Pressure Sensor - Remove and Install
G3304 and G3306 Engines Timing Gear Plate - Remove and Install
C7 On-Highway Engine Speed/Timing Sensor - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
G3304 and G3306 Engines Timing Gears - Install
C15 On-Highway Engines Electronic Unit Injector - Adjust
C7 On-Highway Engine Unit Injector Hydraulic Pump - Install
C7 On-Highway Engine Housing (Front) - Install
G3304 and G3306 Engines Engine Oil Pan - Remove
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Design
C7 On-Highway Engine Front Cover - Remove
G3500B Engines Engine Governing
G3500B Engines Integrated Temperature Sensing Module
C7 On-Highway Engine Front Cover - Install
3054E Industrial Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Engine Oil Pan - Install
C1.5 and C2.2 Generator Bearing - Remove and Install
C11, C13 and C15 On-highway Engines Trip Parameters