Engine Oil Pan - Remove
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Drain the oil from the oil pan.
- Remove the oil level gauge.
Show/hide table
Illustration 1 g00989434 - Disconnect tube assembly (1) from the engine block.
- Disconnect nut (3) from the oil pan and remove tube assembly (1) and oil gauge tube (2) as a unit.
Show/hide table
Illustration 2 g00989435 - Remove bolts (4) and the washers that hold oil pan (5) in position and remove the oil pan.
- Remove the old gasket from oil pan (5).
Caterpillar Information System:
C7 On-Highway Engine Housing (Front) - Install
C7 On-Highway Engine Unit Injector Hydraulic Pump - Install
C7 On-Highway Engine Housing (Front) - Remove
G3500B Engines Engine Governing
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C7 and C9 On-Highway Engines Intermittent Low Power or Power Cutout
C7 On-Highway Engine Boost Pressure Sensor - Remove and Install
G3304 and G3306 Engines Timing Gear Plate - Remove and Install
C7 On-Highway Engine Speed/Timing Sensor - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Design
C7 On-Highway Engine Front Cover - Remove
G3500B Engines Engine Governing
G3500B Engines Integrated Temperature Sensing Module
C7 On-Highway Engine Front Cover - Install
3054E Industrial Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Engine Oil Pan - Install
C1.5 and C2.2 Generator Bearing - Remove and Install
C11, C13 and C15 On-highway Engines Trip Parameters
C7 On-highway Engine Belt Tensioner - Remove and Install
3516B HD Generator Set Generator Set Description
G3500B Engines Engine Sensors