Housing (Front) - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 8T-9011 | Component Cleaner | 1 |
B | 4C-9500 | Quick Cure Primer | 1 |
C | 1U-8846 | Gasket Sealant | 1 |
- Clean the joint face on front housing (4) with Tooling (A).
- Apply Tooling (B) to the joint face. Allow the primer to dry for at least three to five minutes.
- Apply Tooling (C) to the joint face. Spread the sealant uniformly. Front housing (4) must be installed within ten minutes of applying the sealant.
- Position front housing (4) on the cylinder block.
- Install bolts (3) and (5).
Show/hide table
Illustration 2 g00989343 - Position front engine support (2) and install bolts (1).
Show/hide table
Illustration 1 | g01125215 |
End By:
- Install the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
- Install the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Install".
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
Caterpillar Information System:
C7 On-Highway Engine Unit Injector Hydraulic Pump - Install
C7 On-Highway Engine Housing (Front) - Remove
G3500B Engines Engine Governing
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C7 and C9 On-Highway Engines Intermittent Low Power or Power Cutout
C7 On-Highway Engine Boost Pressure Sensor - Remove and Install
G3304 and G3306 Engines Timing Gear Plate - Remove and Install
C7 On-Highway Engine Speed/Timing Sensor - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
3054E Industrial Engine Housing (Front) - Install
C7 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
G3304 and G3306 Engines Engine Oil Pan - Remove
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Design
C7 On-Highway Engine Front Cover - Remove
G3500B Engines Engine Governing
G3500B Engines Integrated Temperature Sensing Module
C7 On-Highway Engine Front Cover - Install
3054E Industrial Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Engine Oil Pan - Install
C1.5 and C2.2 Generator Bearing - Remove and Install
C11, C13 and C15 On-highway Engines Trip Parameters
C7 On-highway Engine Belt Tensioner - Remove and Install
3516B HD Generator Set Generator Set Description