Usage:
Start By:
a. remove rear wheel brakes *
*This operation is in the machine systems Disassembly And Assembly section.
1. Drain the oil from the differential case.
2. Remove four bolts to disconnect brake oil cooler inlet line (3) and outlet line (1) from the axle housing. Put identification marks on two brake lines (2), and remove them from the axle housing.
3. Install tool (A), and fasten a hoist to axle housing (4) as shown.
4. Remove nuts (5) and washers that fasten the axle housing to the differential housing. Remove the axle housing from the differential housing.
5. Inspect the condition of the O-ring seal between the axle housing and differential housing, and make a replacement if necessary.
NOTE: Bolts (6) and (7) for the rear wheel brakes must be in position in the axle housing when the axle housing is installed.
6. Put the axle housing in position on the differential housing.
7. Put 4C5593 Anti-Seize Compound on the threads of nuts (5) and washer faces that fasten the axle housing to the differential housing. Install the nuts and washers. Tighten the nuts to a torque of 715 ± 25 N·m (525 ± 20 lb ft).
8. Install two brake lines (2) on the axle housing. Install brake oil cooler inlet line (3) and outlet line (1) with four bolts.
9. Fill the differential housing with oil to the correct level. See Operation And Maintenance Manual.
End By:
a. install rear wheel brakes *
*This operation is in the machine systems Disassembly And Assembly section.