Usage:
Start By:
a. install body retaining pin
1. Fasten a nylon strap and a hoist to rear drive shaft (1).
2. Remove bolts (2) that fasten each end of the drive shaft to the transmission and differential.
3. Use the hoist, and lower drive shaft (1) to the ground. The weight of the rear drive shaft is 45 kg (100 lb).
NOTE: The following steps are for installation of the rear drive shaft.
4. Put rear drive shaft (1) in position under the vehicle. Fasten a nylon strap and a hoist to the drive shaft, and put the drive shaft in position between the transmission and differential.
5. Install bolts (2) that hold each end of the drive shaft to the transmission and differential. Tighten the bolt to a torque of 135 ± 15 N·m (100 ± 11 lb ft).
End By:
a. remove body retaining pins