Removal Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
2P-8250     |
Strap Wrench     |
1     |
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification on all lines, hoses, wires, and tubes for installation purposes. Install a cap or a plug in all lines, hoses, or tubes that are disconnected in order to prevent fluid loss. The caps or the plugs will also prevent foreign material from entering the system.
Show/hide table
|
|
|
Illustration 1 | g00555919 |
- Open the access door and pull the knob for the fuel supply valve all the way outward in order to close the valve.
Show/hide table
|
|
|
Illustration 2 | g00555479 |
- Remove six bolts (2) and engine access panel (1) from the right side of the machine.
Show/hide table
|
|
|
Illustration 3 | g00557804 |
- Remove access door (3) for the fuel priming pump.
Show/hide table
|
|
|
Illustration 4 | g00557806 |
- Use Tool (A) to remove fuel filter (4) from fuel filter base (5) .
Show/hide table
|
|
|
Illustration 5 | g00557807 |
- Disconnect fuel lines (6) and (7) from fuel filter base (5) .
Show/hide table
|
|
|
Illustration 6 | g00557808 |
- Remove bolts (8) and fuel filter base (5) .
Installation Procedure
Show/hide table
|
|
|
Illustration 7 | g00557808 |
- Put fuel filter base (5) in position and install bolts (8) .
Show/hide table
|
|
|
Illustration 8 | g00557807 |
- Connect fuel lines (6) and (7) to fuel filter base (5) .
Show/hide table
|
|
|
Illustration 9 | g00557806 |
- Install fuel filter (4) to fuel filter base (5) by hand. When the seal on the filter contacts the filter base, tighten the filter by an additional 3/4 turn.
Show/hide table
|
|
|
Illustration 10 | g00555919 |
- Open the access door and push the knob for the fuel supply valve all the way inward in order to open the valve. Prime the fuel system.
Note: Refer to the Operation and Maintenance Manual, SEBU7156, "Fuel System - Prime" for the proper procedure to prime the fuel system.
Show/hide table
|
|
|
Illustration 11 | g00555479 |
- Put engine access panel (1) in position and install six bolts (2) .