Engine Front Support - Install
安装步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件说明     | 数量     |
A     | FT-1321     | 支撑梁     | 1     |
1D-4706 | 螺栓 (3/8 - 16 NC X 6 in)     |
4     | |
B     | 4C-6486     | 台架     | 1     |
8S-7621 | 管     | 1     | |
8S-7625 | 套环     | 1     | |
8S-7615 | 销     | 1     | |
8S-7650 | 气缸     | 1     | |
8S-7645 | 软管     | 1     | |
3S-6224 | 电动液压泵     | 1     | |
C     | 8S-7615     | 销     | 1     |
D     | 9S-3263     | 螺纹锁固胶     | -     |
- 安装前确认发动机前支架的所有部件清洁无异物。
- 检查所有部件是否磨损,必要时更换部件。
- 将支架组件 (9) 定位到耳轴上。
Show/hide table
图 1 | g00518497 |
- 将工具 (D) 涂抹到螺栓 (8) 的螺纹上。 安装将支架组件 (9) 固定到耳轴上的螺栓 (8) 。
- 利用工具 (B) 吊起发动机前端,直到可以拆下工具 (C) 为止。
Show/hide table
图 2 | g00518493 |
Show/hide table
图 3 | g00518429 |
- 利用工具 (B) 下放发动机前端,直到前发动机支架坐到支架组件上。
- 安装将前发动机支架固定到支架组件上的螺栓 (3) 。 拧紧螺栓 (3) 至扭矩为 475 ± 60 N·m (350 ± 44 lb ft)。 拆下工具 (B) 。
- 将减振器适配器 (2) 安装到曲轴上。 安装螺栓 (1) 。
Show/hide table
图 4 | g00518278 |
Show/hide table
图 5 | g00518253 |
- 将工具 (A) 从缸体组件的底部拆下。
Show/hide table
图 6 | g00518241 |
- 将盖 (7) 上的螺栓 (6) 上紧到 475 ± 60 N·m (350 ± 44 lb ft) 的扭矩。
Show/hide table
图 7 | g00584513 |
- 将盖 (5) 上的螺栓 (4) 上紧到 475 ± 60 N·m (350 ± 44 lb ft) 的扭矩。
Show/hide table
图 8 | g00584512 |
End By:
- 安装减振器。 请参阅 拆解和组装, "减振器 - 拆卸和安装"。
- 安装风扇驱动装置。 请参阅 拆解和组装, "风扇驱动装置 - 安装"。
- 安装油底壳。 请参阅 拆解和组装, "油底壳 - 安装"。
Caterpillar Information System:
69D and 769D Off-Highway Truck and 771D Quarry Truck Air System and Brakes Temperature Sensor (Brake Oil)
3176C and 3196 Industrial Engines Speed/Timing Sensor - Remove and Install
3176C and 3196 Industrial Engines Engine Oil Pressure Sensor - Remove and Install
784C and 785C Off-Highway Trucks Machine Systems Window Wiper Motor - Remove and Install
824G , 825G and 826G Landfill Compactor Cleaner Bar Tips - Replace
980G Wheel Loader Power Train Axle Shaft - Remove and Install
793C and 793C XQ Off-Highway Trucks Hydraulic System Relief Valve (Brake Oil Cooler) - Test and Adjust
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Oil in Cooling System
TK711, TK721, TK722 and TK732 Track Feller Bunchers Machine Systems Swing Drive - Disassemble
554 Forwarder and 574 Forwarder Stopping the Machine
793C Off-Highway Truck/Tractor Power Train Lateral Control Rod (Rear Axle Housing) - Assemble
517 Track-Type Skidder Engine Supplement Fuel Filter (Primary) and Fuel Filter Base - Remove and Install
69D and 769D Off-Highway Trucks and 771D Quarry Truck Power Train Pressure Switch (Secondary Brake and Parking Brake)
69D and 769D Off-Highway Trucks and 771D Quarry Truck Power Train Pressure Switch (Service Brake and Retarder)
3524B Engines for Off-Highway Trucks Fuel in Cooling System
3500B and 3500B High Displacement Generator Set Engines Oil Contains Coolant
D250E Series II and D300E Series II Articulated Trucks Power Train Transmission Hydraulic Control Valve - Remove
784C and 785C Off-Highway Trucks Machine Systems Steering Accumulator - Remove
517 Track-Type Skidder Engine Supplement Fuel Priming Pump - Remove and Install
517 Track-Type Skidder Engine Supplement Fuel Transfer Pump - Remove
517 Track-Type Skidder Engine Supplement Fuel Transfer Pump - Disassemble
517 Track-Type Skidder Engine Supplement Fuel Transfer Pump - Assemble
517 Track-Type Skidder Engine Supplement Fuel Transfer Pump - Install
517 Track-Type Skidder Engine Supplement Hood - Remove and Install