Engine Oil Filter Base - Assemble
Assembly Procedure
Show/hide table
Illustration 1 | g00556813 |
- If the stud for the oil filter was removed, do the following procedure: Put 9S-3263 Thread Lock only on the threaded end of the stud that will be installed into the oil filter base.
- Install the stud in the oil filter base and tighten to a torque of 70 ± 7 N·m (50 ± 5 lb ft).
- Install plungers (7) and (8) and springs (5) and (6) in the oil filter base.
Show/hide table
NOTICE |
---|
Be sure that you install plungers (7) and (8) in the original location in the oil filter base. |
- Use bolts (3) to install cover (4) to the oil filter base.
- Install O-ring seal (2) and plug (1) .
End By: Install the engine oil filter base.
Caterpillar Information System:
517 Track-Type Skidder Engine Supplement Engine Oil Filter and Base - Remove
517 Track-Type Skidder Engine Supplement Engine and Torque Converter - Remove
517 Track-Type Skidder Engine Supplement Engine and Torque Converter - Install
517 Track-Type Skidder Engine Supplement Electric Starting Motor - Remove and Install
517 Track-Type Skidder Engine Supplement Alternator - Remove and Install
517 Track-Type Skidder Engine Supplement Air Cleaner - Remove and Install
Caterpillar Monitoring System Charge Pressure Display Mode
69D and 769D Off-Highway Trucks and 771D Quarry Truck Power Train Transmission Gear Indicator
3412E Engine Supplement for 773D Off-Highway Trucks and 775D Off-Highway Quarry Trucks Engine Front Support - Remove
784C and 785C Off-Highway Trucks Machine Systems Cab - Install
3406E On-Highway Engine Engine Oil Pressure Sensor - Remove and Install
Caterpillar Monitoring System Engine Oil Pressure Display Mode
517 Track-Type Skidder Engine Supplement Engine Oil Filter Base - Disassemble
517 Track-Type Skidder Engine Supplement Engine Oil Filter and Base - Install
69D and 769D Off-Highway Truck and 771D Quarry Truck Air System and Brakes Service and Parking Brake (Rear)
517 Track-Type Skidder Engine Supplement Fan Drive - Disassemble
517 Track-Type Skidder Engine Supplement Fan Drive - Assemble
517 Track-Type Skidder Engine Supplement Fuel Filter (Primary) and Fuel Filter Base - Remove and Install
793C Off-Highway Truck/Tractor Power Train Lateral Control Rod (Rear Axle Housing) - Assemble
554 Forwarder and 574 Forwarder Stopping the Machine
TK711, TK721, TK722 and TK732 Track Feller Bunchers Machine Systems Swing Drive - Disassemble
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Oil in Cooling System
793C and 793C XQ Off-Highway Trucks Hydraulic System Relief Valve (Brake Oil Cooler) - Test and Adjust
980G Wheel Loader Power Train Axle Shaft - Remove and Install