Usage:
Problem:
THE AUGER LIFT CYLINDERS MAY NOT LOWER EVENLY.
Solution:
Check the auger lift cylinders for proper operation. Raise the auger to the up position. Lower the auger to the down position. Measure the length of the lift cylinders while they are fully extended. The length of the lift cylinders should measure 540 mm (± 10 mm) from the center of each eye. If the cylinders are not within the 540 mm (± 10 mm) range, the hose routing must be changed.
Locate the auger lift cylinder hoses on the rear side of the machine. There are two auger lift cylinder hoses on each side of the machine. Remove hose (1) and hose (2) from the bulkheads on each side of the machine. Install hose (1) on the bulkhead vacated by hose (2). Install hose (2) on the bulkhead vacated by hose (1). Also, reverse the wires on the switch for the auger lift cylinders. Wire P717-pk should be reversed with wire P716-wh.
COPYRIGHT 2002 CATERPILLAR ALL RIGHTS RESERVED