S.O.S Sampling During Winter Inspections And One Hundred Hour Service
Usage:
COMBINES450 (8YW),
460 (9FW),
465 (3HZ),
470 (9TW),
470 R (766),
475 R (767),
480 (2BZ),
480 R (866),
485 (8ZW),
485 R (868) COMBINES
Attn: James Gerstenkorn
8401 S 132nd ST
Omaha, NE 68138
Fax 1-402-861-1003
460 (9FW),
465 (3HZ),
470 (9TW),
470 R (766),
475 R (767),
480 (2BZ),
480 R (866),
485 (8ZW),
485 R (868) COMBINES
Problem:
Additional S.O.S data is needed from the field in order to establish S.O.S guidelines.
Solution:
During your one hundred hour service this winter, obtain S.O.S. samples and send the results to the Product Group. See the Operator and Maintenance Manual, Obtaining S.O.S Samples
The following components have one hundred hour oil change requirements.
- * Engine Transfer Gear Housing
- * Final Drives (Wheeled Machines Only)
- * Rotor Bevel Gear Housing
- * Threshing Cylinder Dual Range Drive
- * Transmission
- * Final Drives (Wheeled Machines Only)
Send copies of oil sample results to:
Caterpillar Claas of AmericaAttn: James Gerstenkorn
8401 S 132nd ST
Omaha, NE 68138
Fax 1-402-861-1003
COPYRIGHT 2001 CATERPILLAR ALL RIGHTS RESERVED
Caterpillar Information System:
Recall And Replacement Of SR17, SR18, And SR21 Snowblowers Recall And Replacement Of SR17, SR18, And SR21 Snowblowers
Pulley Misalignment Can Cause Premature Wear Of The Drive Belt For The Refrigerant Compressor Pulley Misalignment Can Cause Premature Wear Of The Drive Belt For The Refrigerant Compressor
Differential Paint Flakes May Plug Suction Screen Differential Paint Flakes May Plug Suction Screen
Multi-Functional Switch Multi-Functional Switch
Auto-Up Stabilizer Auto-Up Stabilizer
Battery Cables May Be Installed Incorrectly Battery Cables May Be Installed Incorrectly
Air Conditioning System May Be Over-Charged Air Conditioning System May Be Over-Charged
CHECK FOR THE CORRECT OIL SAMPLING AND PRESSURE TEST POINT NIPPLE FOR THE OTG CHECK FOR THE CORRECT OIL SAMPLING AND PRESSURE TEST POINT NIPPLE FOR THE OTG
Failure Of The N-Pin Retaining Bolts For The Lift Arms Failure Of The N-Pin Retaining Bolts For The Lift Arms
Failure Of The 156-0890 Fork Assembly For The Industrial Grapple Bucket Failure Of The 156-0890 Fork Assembly For The Industrial Grapple Bucket
Failure Of The Hub For The 161-5856 Planetary Gp Failure Of The Hub For The 161-5856 Planetary Gp
Installation Procedure For The Burner Assembly Glow Plugs Installation Procedure For The Burner Assembly Glow Plugs
Cracking Of The 9N-0720 Elbow In The Engine Air Intake Lines Cracking Of The 9N-0720 Elbow In The Engine Air Intake Lines
Hydraulic Lift Cylinder Seal Failures Hydraulic Lift Cylinder Seal Failures
Cab Roof Seams May Allow Moisture Ingress Cab Roof Seams May Allow Moisture Ingress
Excessive Blow-By And Oil Consumption Complaints Excessive Blow-By And Oil Consumption Complaints
Improper Hose Routing On Auger Lift Cylinders Improper Hose Routing On Auger Lift Cylinders
External Ejector Cylinder Leakage External Ejector Cylinder Leakage
The 108-0358 Electronic Flasher Assembly Is Not A Drop-in Replacement For The 8D-6946 Flasher The 108-0358 Electronic Flasher Assembly Is Not A Drop-in Replacement For The 8D-6946 Flasher
7E6248 Jacket Water Heater Group 7E6248 Jacket Water Heater Group
Fuel Dilution Of The Oil In 3500B Engines Fuel Dilution Of The Oil In 3500B Engines
Parking and Secondary Brake Holding Ability Test Parking and Secondary Brake Holding Ability Test
834G Wheel Tractor and 836G Landfill Compactor Calibrations Require Caterpillar Electronic Technician (Cat ET) 2001B-Service Pack 1 Software or Later 834G Wheel Tractor and 836G Landfill Compactor Calibrations Require Caterpillar Electronic Technician (Cat ET) 2001B-Service Pack 1 Software or Later
Failures of 161-1343 Transmission Control on Motor Graders Failures of 161-1343 Transmission Control on Motor Graders