Updated 133-6350 EMCP II Generator Set Control Group Corrects Hourmeter Programming and Spare Fault Operation{4490}
Usage:
All Generator Sets Equipped With Electronic Modular Control Panel II
Description of Change: Early versions of this EMCP II Genset Control were not able to advance the hourmeter or activate the fault alarm indicator during a Spare fault. A new change level has been assigned to correct these problems.
Adaptable To: The 133-6350 Control Group (change level 02) is now available which incorporates solutions for both of the problems. The part number-change level can be found on the control casting just above the 40 pin connector.
Caterpillar Information System:
1999/04/01 Special Instruction, REHS0345-01, "Generator Service Literature Index" Is Available{4450}
1999/04/01 Improved Data Logger Feature For Customer Communication Module{1926}
1999/04/01 New 155-5175 AC Current Probe For Generator Sets Now Available{1400,4450}
1999/04/01 Protection From Paint Is Required For The G3600 Hydraulic Actuator (Hydrax) Shaft{1909,7581}
1999/04/01 New Cover And Plate Assembly Used In Oil Level Contactor Groups To Help Resist Vibration Damage{1326,7450}
1999/04/01 Heinzmann Wastegate Actuator Relocated{1057}
1999/04/01 Using The Correct Diode When Using The Customer Communication Module In Multiple Engine Applications{1902,0374}
1999/04/01 Be Sure To Use The Correct Gas Fuel Pressure{1250,1270,1293}
1999/04/01 New Exhaust Manifold Group Seals Provides Improved Exhaust Gas Sealing{1059}
1999/04/01 Re-Alignment Warning Tag On All 3500 Generator Sets Reminds Of Alignment Required At Installation{1021}
1999/04/01 New Oil Pump Group Used{1304}
1999/04/01 Use 154-8100 Fuel System Arrangement And 154-8101 Fuel System Group To Measure Engine Fuel Flow{1250,0782}
1999/04/01 New Control Panel Films Show That SR4B Generators Are Not To Be Wired In The Delta Configuration{7557,7566}
1999/05/01 Use 157-3722 Driver To Remove And Install Engine Valve Guides{0703,1104}
1999/05/01 Cold Start Advance Solenoid Available{1272,1250}
1999/05/01 New Design Of Cylinder Block And Main Bearings{1201,1203,1224}
1999/05/01 New Block Cover Used{1201}
1999/05/01 New Stainless Steel Filler Neck Now Used In Radiator Groups{1353}
1999/05/01 Use 125-5597 Mounting Bar To Disassemble And Assemble Heat Exchanger{1379}
1999/05/01 New Breakout Harness{1559}
1999/05/01 New Turbocharger Supports Help Prevent Watercooled Exhaust Manifold Cracking{1059,1052}
1999/05/01 New Basic Cylinder Head Group Used In 3500B High Speed Commercial Engines{1100,1103,1105}
1999/05/01 New Flywheel Housing Assembly Available{1157}
1999/05/01 Changes To High Pressure Gas Regulator Assembly Provide Improved Response{1270,1283}