Camshaft Bearings
Show/hide table
| |
| Illustration 1 | g06071198 |
Show/hide table
| Specifications for 370-6545 Camshaft Bushing | |||
|---|---|---|---|
| Item | Qty | Part | Specification Description |
| 1 | - | 370-6545 Camshaft Bushing | Diameter of the installed camshaft bearing is |
Show/hide table
| |
| Illustration 2 | g06070675 |
Show/hide table
| Item | Qty | Part | Specification Description |
|---|---|---|---|
| 2 | - | 133-1011 Washer | Outer diameter of washer (A) is Thickness of washer (B) is |
| - | - | - | Check the camshaft lobes for visible damage. If a new camshaft is installed, you must install new lifters. |
Caterpillar Information System:
C7.1 Marine Propulsion Engine Rocker Shaft
XQ60 Rental Generator Set Control Panel
C12.9 Marine Engines Bearing Clearance - Check
C7.1 Marine Propulsion Engine Lifter Group
Procedure For Restoration of Flywheel Lockout {4480} Procedure For Restoration of Flywheel Lockout {4480}
320 GC, 320 and 323 Excavator Work Tool Control (Two-Way Flow) - If Equipped
320 GC, 320 and 323 Excavator Joystick Controls Alternate Patterns
320 GC, 320 and 323 Excavator Work Tool Control (One-Way Flow) - If Equipped
320 GC, 320 and 323 Excavator SmartBoom Control - If Equipped
320 GC, 320 and 323 Excavator Joystick Controls - Medium Pressure (If Equipped)
320 GC, 320 and 323 Excavator Fuel Tank Shutoff and Drain Control
320 GC, 320 and 323 Excavator Shovel Crane Control - If Equipped
C7.1 Marine Propulsion Engine Camshaft
3516C Locomotive Engine and Generator Set Overhaul (Major)
XQ60 Rental Generator Set Refill Capacities and Recommendations
New Heat Shields Are Used on Certain C175 Locomotive Engines {1067} New Heat Shields Are Used on Certain C175 Locomotive Engines {1067}
3512E Engines Muffler - Remove and Install
A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319} A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319}
Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063} Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063}
Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100} Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100}
G3512 Generator Set Engines Configuration Parameters
C12.9 Marine Engines Engine Oil Cooler - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (Second Stage) - Remove and Install
XQ60 Rental Generator Set Cooling System Coolant Level - Check