Muffler - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Loctite C5-A Copper Anti-Seize Lubricant | - |
Show/hide table
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool. |
Show/hide table
Wear goggles, gloves, protective clothing, and a National Institute for Occupational Safety and Health (NIOSH) approved P95 or N95 half-face respirator when handling a used Diesel Particulate Filter or Catalytic Converter Muffler. Failure to do so could result in personal injury. |
- Remove bolts (3).
- Remove bolts (2), exhaust elbow (1) and the gasket.
Show/hide table
Illustration 2 g06071121 - Remove bolts (5) and loosen clamps (4).
- Use a suitable lifting device to remove muffler (6) and the gasket. The weight of muffler (6) is approximately
140 kg (309 lb) .
Show/hide table
Illustration 1 | g06071082 |
- Install muffler (6) in the reverse order of removal.
- Apply Tooling (A) to the threads of bolts (2) and bolts (3).
Caterpillar Information System:
New Heat Shields Are Used on Certain C175 Locomotive Engines {1067} New Heat Shields Are Used on Certain C175 Locomotive Engines {1067}
XQ60 Rental Generator Set Refill Capacities and Recommendations
3516C Locomotive Engine and Generator Set Overhaul (Major)
C7.1 Marine Propulsion Engine Camshaft
C7.1 Marine Propulsion Engine Camshaft Bearings
C7.1 Marine Propulsion Engine Rocker Shaft
XQ60 Rental Generator Set Control Panel
C12.9 Marine Engines Bearing Clearance - Check
C7.1 Marine Propulsion Engine Lifter Group
Procedure For Restoration of Flywheel Lockout {4480} Procedure For Restoration of Flywheel Lockout {4480}
320 GC, 320 and 323 Excavator Work Tool Control (Two-Way Flow) - If Equipped
320 GC, 320 and 323 Excavator Joystick Controls Alternate Patterns
A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319} A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319}
Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063} Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063}
Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100} Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100}
G3512 Generator Set Engines Configuration Parameters
C12.9 Marine Engines Engine Oil Cooler - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (Second Stage) - Remove and Install
XQ60 Rental Generator Set Cooling System Coolant Level - Check
C7.1 Marine Propulsion Engine Cylinder Head Valves
C7.1 Marine Propulsion Engine Cylinder Block
Selective Catalytic Reduction Retrofit Aftertreatment Aftertreatment Identification Module - Test
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Supply - Test
3512E Engines Catalytic Converter - Remove and Install