- Engine
- C175 Engines
Introduction
This special instruction describes where to use the 370-8028 Integral Seal and the 394-0295 Integral Seal. Verify that the correct integral seal is used prior to installing the cylinder head. If using a single cylinder head gasket kit for a field repair, verify that the kit contains the same integral seal part number as the integral seal that is removed from the engine.
Reference Section
The 370-8028 Integral Seal (Standard Integral Seal) is for use on a cylinder block that has not had the top deck milled or on a cylinder block that has been milled. The cylinder block has a top deck height between
The 394-0295 Integral Seal (Thicker Integral Seal) is for use on a cylinder block that has had the top deck milled. The cylinder block has a top deck height between
Refer to Table 1 and Illustration 1 for additional information.
Top Deck Height Requirements and Integral Seal Part Numbers | |||
---|---|---|---|
Part Number | Top Deck Height | Minimum Valve | Maximum Value |
Dimension (G)(1) | |
|
|
Dimension (G)(1) | |
|
(1) | Refer to dimension (G) in Illustration 1. |
Illustration 1 | g06071400 |