Cooling System Coolant Level - Check
Check the coolant level when the engine is stopped and cool.
Show/hide table
Illustration 1 | g06071136 |
(1) Access for the cooling system filler cap |
Show/hide table
Pressurized System: Hot coolant can cause serious burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. |
- Remove the cooling system filler cap slowly to relieve pressure.
- Maintain the coolant level within
13 mm (0.5 inch) of the bottom of the filler pipe. If the engine is equipped with a sight glass, maintain the coolant level to the proper level in the sight glass.Show/hide tableIllustration 2 g00103639 Typical filler cap gaskets - Clean the cooling system filler cap and check the condition of the filler cap gaskets. Replace the cooling system filler cap if the filler cap gaskets are damaged. Reinstall the cooling system filler cap.
- Inspect the cooling system for leaks.
Caterpillar Information System:
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (Second Stage) - Remove and Install
C12.9 Marine Engines Engine Oil Cooler - Remove and Install
G3512 Generator Set Engines Configuration Parameters
Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100} Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100}
Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063} Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063}
A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319} A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319}
3512E Engines Muffler - Remove and Install
New Heat Shields Are Used on Certain C175 Locomotive Engines {1067} New Heat Shields Are Used on Certain C175 Locomotive Engines {1067}
XQ60 Rental Generator Set Refill Capacities and Recommendations
3516C Locomotive Engine and Generator Set Overhaul (Major)
C7.1 Marine Propulsion Engine Camshaft
C7.1 Marine Propulsion Engine Camshaft Bearings
C7.1 Marine Propulsion Engine Cylinder Head Valves
C7.1 Marine Propulsion Engine Cylinder Block
Selective Catalytic Reduction Retrofit Aftertreatment Aftertreatment Identification Module - Test
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Supply - Test
3512E Engines Catalytic Converter - Remove and Install
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Signal (Analog, Passive) - Test
XQ60 Rental Generator Set Engine Oil and Filter - Change
XQ60 Rental Generator Set Stopping the Engine
XQ60 Rental Generator Set Fuel Tank Water and Sediment - Drain
3512E Engines Engine Oil Pressure Sensor - Remove and Install
C7.1 Marine Propulsion Engine Connecting Rod Bearing Journal
C7.1 Marine Propulsion Engine Main Bearing Journal