Engine Oil Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the harness assembly and remove filtered engine oil pressure sensor (2).
- Remove the O-ring seal from the engine oil pressure sensor.
- Disconnect the harness assembly and remove unfiltered engine oil pressure sensor (1).
- Remove the O-ring seal from the engine oil pressure sensor.
Show/hide table
Illustration 1 | g06071674 |
- Install a new O-ring seal on filtered engine oil pressure sensor (2). Apply clean engine oil to the O-ring seal.
- Install filtered engine oil pressure sensor (2) and tighten to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect the harness assembly.
- Install a new O-ring seal on unfiltered engine oil pressure sensor (1). Apply clean engine oil to the O-ring seal.
- Install unfiltered engine oil pressure sensor (1) and tighten to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect the harness assembly.
Show/hide table
Illustration 2 | g06071674 |
Caterpillar Information System:
XQ60 Rental Generator Set Fuel Tank Water and Sediment - Drain
XQ60 Rental Generator Set Stopping the Engine
XQ60 Rental Generator Set Engine Oil and Filter - Change
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Signal (Analog, Passive) - Test
3512E Engines Catalytic Converter - Remove and Install
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Supply - Test
Selective Catalytic Reduction Retrofit Aftertreatment Aftertreatment Identification Module - Test
C7.1 Marine Propulsion Engine Cylinder Block
C7.1 Marine Propulsion Engine Cylinder Head Valves
XQ60 Rental Generator Set Cooling System Coolant Level - Check
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (Second Stage) - Remove and Install
C12.9 Marine Engines Engine Oil Cooler - Remove and Install
C7.1 Marine Propulsion Engine Connecting Rod Bearing Journal
C7.1 Marine Propulsion Engine Main Bearing Journal
G3512 Generator Set Engines Coolant Pressure Is Low
C7.1 Marine Propulsion Engine Connecting Rod
C7.1 Marine Propulsion Engine Engine Support (Rear)
C7.1 Marine Propulsion Engine Fuel Lines
C7.1 Marine Propulsion Engine Belt Guard
3512E Engines Pressure Sensor (NRS Differential) - Remove and Install
C7.1 Marine Propulsion Engine Aftercooler
C7.1 Marine Propulsion Engine Heat Exchanger
C7.1 Marine Propulsion Engine Auxiliary Sea Water Pump
C7.1 Marine Propulsion Engine Engine Mounting