Catalytic Converter - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Loctite C5-A Copper Anti-Seize Lubricant | - |
Show/hide table
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool. |
Show/hide table
Wear goggles, gloves, protective clothing, and a National Institute for Occupational Safety and Health (NIOSH) approved P95 or N95 half-face respirator when handling a used Diesel Particulate Filter or Catalytic Converter Muffler. Failure to do so could result in personal injury. |
- Remove bolts (1) and bolts (2).
Show/hide table
Illustration 2 g06071511 - Remove nuts (3).
Show/hide table
Illustration 3 g06071556 - Use a suitable lifting device to remove catalytic converter (4). The weight of catalytic converter (4) is approximately
103 kg (227 lb) .
Show/hide table
Illustration 1 | g06071406 |
- Install catalytic converter (4) in the reverse order of removal.
- Apply Tooling (A) to the threads of nuts (3).
Caterpillar Information System:
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Supply - Test
Selective Catalytic Reduction Retrofit Aftertreatment Aftertreatment Identification Module - Test
C7.1 Marine Propulsion Engine Cylinder Block
C7.1 Marine Propulsion Engine Cylinder Head Valves
XQ60 Rental Generator Set Cooling System Coolant Level - Check
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (Second Stage) - Remove and Install
C12.9 Marine Engines Engine Oil Cooler - Remove and Install
G3512 Generator Set Engines Configuration Parameters
Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100} Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100}
Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063} Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063}
A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319} A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319}
3512E Engines Muffler - Remove and Install
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Signal (Analog, Passive) - Test
XQ60 Rental Generator Set Engine Oil and Filter - Change
XQ60 Rental Generator Set Stopping the Engine
XQ60 Rental Generator Set Fuel Tank Water and Sediment - Drain
3512E Engines Engine Oil Pressure Sensor - Remove and Install
C7.1 Marine Propulsion Engine Connecting Rod Bearing Journal
C7.1 Marine Propulsion Engine Main Bearing Journal
G3512 Generator Set Engines Coolant Pressure Is Low
C7.1 Marine Propulsion Engine Connecting Rod
C7.1 Marine Propulsion Engine Engine Support (Rear)
C7.1 Marine Propulsion Engine Fuel Lines
C7.1 Marine Propulsion Engine Belt Guard