New Heat Shields Are Used on Certain C175 Locomotive Engines {1067}
- Locomotive Engine
- C175-16 (S/N: 3A91-UP; Y3A1-UP; KWT1-UP)
Description Of Change: The new heat shields were designed to allow a minimum clearance of
The new heat shields allow the exhaust manifold clamps to rotate 20 degrees.
The new heat shields allow the turbocharger turbine inlet thermocouples to be oriented and serviced without removing the heat shields.
Adaptable To: The new heat shields replace the former heat shields.
The new heat shields are adaptable to the above engines back to first production.
Note: The new heat shields are not compatible with the former heat shields.
The new heat shields and the former heat shields are listed in Table 1.
Show/hide table
| New Part Number | Part Name | Former Part Number |
|---|---|---|
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As | ||
| Shield As |
Show/hide table
| Effective Serial Numbers |
|---|
| S/N:3A900137-UP |
| S/N:KWT00135-UP |
| S/N:Y3A00137-UP |
Show/hide table
| |
| Illustration 1 | g06071062 |
|
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) | |
Caterpillar Information System:
XQ60 Rental Generator Set Refill Capacities and Recommendations
3516C Locomotive Engine and Generator Set Overhaul (Major)
C7.1 Marine Propulsion Engine Camshaft
C7.1 Marine Propulsion Engine Camshaft Bearings
C7.1 Marine Propulsion Engine Rocker Shaft
XQ60 Rental Generator Set Control Panel
C12.9 Marine Engines Bearing Clearance - Check
C7.1 Marine Propulsion Engine Lifter Group
Procedure For Restoration of Flywheel Lockout {4480} Procedure For Restoration of Flywheel Lockout {4480}
320 GC, 320 and 323 Excavator Work Tool Control (Two-Way Flow) - If Equipped
320 GC, 320 and 323 Excavator Joystick Controls Alternate Patterns
320 GC, 320 and 323 Excavator Work Tool Control (One-Way Flow) - If Equipped
3512E Engines Muffler - Remove and Install
A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319} A New Prelube Pump Oil Tube Assembly Is Used on Certain 3516C Commercial Engines {1319}
Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063} Assembly Procedure For Aftercooler Bonnet Group On Certain G3500 and CG170-16 Engines {1063}
Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100} Use of the 370-8028 Integral Seal and the 394-0295 Integral Seal {1100}
G3512 Generator Set Engines Configuration Parameters
C12.9 Marine Engines Engine Oil Cooler - Remove and Install
PM820, PM822, and PM825 Cold Planer Machine Systems Conveyor (Second Stage) - Remove and Install
XQ60 Rental Generator Set Cooling System Coolant Level - Check
C7.1 Marine Propulsion Engine Cylinder Head Valves
C7.1 Marine Propulsion Engine Cylinder Block
Selective Catalytic Reduction Retrofit Aftertreatment Aftertreatment Identification Module - Test
Selective Catalytic Reduction Retrofit Aftertreatment Sensor Supply - Test